Quasi-realistic solo harpsichord sound. Very simplistic setup. May want to slightly adjust Amp EG release depending on speed of music being played.
Select any preset on the microKORG, then send the sysex data from the patches here using a MIDI system exclusive utility for your computer. The patch should load in “audition” mode on the microKORG. Play and tweak as needed, then save the new sound using the “Write” button.
If nothing happens when transmitting the sysex data, try setting the microKORG to receive on a different MIDI channel.
Synth/Vocoder: | Synth |
Single/Layer: | Single |
Voice Assign: | Poly |
Transpose: | 0 |
Tune: | 0 |
Portamento: | 0 |
Bend Range: | 2 |
Vibrato Int: | 5 |
Wave: | Digital |
Control 1: | 0 |
Control 2: | 19 |
Wave: | Saw |
Oscillator Mod: | Sync |
Semitone: | 0 |
Tune: | 0 |
OSC 1 Level: | 127 |
OSC 2/Inst Level: | 0 |
Noise Level: | 0 |
Type: | -24dB LPF |
Cutoff: | 127 |
Resonance: | 20 |
Filter EG Int: | 0 |
Filter Key Track: | 0 |
Attack: | 0 |
Decay: | 41 |
Sustain: | 0 |
Release: | 0 |
EG Reset: | On |
Level: | 127 |
Panpot: | 0 |
Distortion: | Off |
Keybd Track: | 0 |
Attack: | 2 |
Decay: | 104 |
Sustain: | 0 |
Release: | 46 |
EG Reset: | On |
Wave: | Triangle |
Key Sync: | |
Tempo Sync: | Off |
Frequency: | 10 |
Wave: | Sine |
Key Sync: | OFF |
Tempo Sync: | Off |
Frequency: | 70 |
Source: | |
Destination: | |
Mod Int: | 0 |
Source: | |
Destination: | |
Mod Int: | 0 |
Source: | |
Destination: | |
Mod Int: | 0 |
Source: | |
Destination: | |
Mod Int: | 0 |
Type: | Chorus/Flanger |
LFO Speed: | 0 |
Effect Depth: | 0 |
Type: | Stereo Delay |
Tempo Sync: | Off |
Delay Time: | 0 |
Delay Depth: | 0 |
Low EQ Freq: | 40Hz |
Low EQ Gain: | -12 |
Hi EQ Freq: | 1kHz |
Hi EQ Gain: | -12 |
Tempo: | 20 |
Resolution: | 1/24 |
Gate: | 100 |
Type: | Up |
Range: | 1 |
Latch: | Off |
Swing: | 0 |
Key Sync: | Off |
Last Step: | 1 |
Enabled: | Off |