A shaker with some groove. Bring up the resonance for more of a rattle sound.
Select any preset on the microKORG, then send the sysex data from the patches here using a MIDI system exclusive utility for your computer. The patch should load in “audition” mode on the microKORG. Play and tweak as needed, then save the new sound using the “Write” button.
If nothing happens when transmitting the sysex data, try setting the microKORG to receive on a different MIDI channel.
Synth/Vocoder: | Synth |
Single/Layer: | Single |
Voice Assign: | Poly |
Transpose: | 0 |
Tune: | 0 |
Portamento: | 0 |
Bend Range: | 2 |
Vibrato Int: | 5 |
Wave: | Saw |
Control 1: | 0 |
Control 2: | 0 |
Wave: | Saw |
Oscillator Mod: | OFF |
Semitone: | 0 |
Tune: | 0 |
OSC 1 Level: | 0 |
OSC 2/Inst Level: | 0 |
Noise Level: | 0 |
Type: | -12dB LPF |
Cutoff: | 115 |
Resonance: | 68 |
Filter EG Int: | 30 |
Filter Key Track: | -9 |
Attack: | 61 |
Decay: | 24 |
Sustain: | 124 |
Release: | 25 |
EG Reset: | Off |
Level: | 127 |
Panpot: | 0 |
Distortion: | On |
Keybd Track: | 0 |
Attack: | 32 |
Decay: | 72 |
Sustain: | 98 |
Release: | 17 |
EG Reset: | On |
Wave: | Sample and Hold |
Key Sync: | Voice |
Tempo Sync: | On |
Sync Note: | 1/32 |
Wave: | Saw |
Key Sync: | Timbre |
Tempo Sync: | On |
Sync Note: | 1/2 |
Source: | LFO 1 |
Destination: | Pitch |
Mod Int: | 0 |
Source: | LFO 2 |
Destination: | Noise Level |
Mod Int: | 37 |
Source: | Amp EG |
Destination: | Noise Level |
Mod Int: | -5 |
Source: | KBD Track |
Destination: | LFO2 Frequency |
Mod Int: | 0 |
Type: | Ensemble |
LFO Speed: | 116 |
Effect Depth: | 23 |
Type: | L/R Delay |
Tempo Sync: | On |
Sync Note: | 1/24 |
Delay Depth: | 88 |
Low EQ Freq: | 60Hz |
Low EQ Gain: | 12 |
Hi EQ Freq: | 5.25kHz |
Hi EQ Gain: | 9 |
Tempo: | 118 |
Resolution: | 1/16 |
Gate: | 100 |
Type: | Alt 1 |
Range: | 4 |
Latch: | On |
Swing: | 0 |
Key Sync: | Off |
Last Step: | 8 |
Enabled: | On |
Step 1: | On |
Step 2: | On |
Step 3: | On |
Step 4: | Off |
Step 5: | On |
Step 6: | On |
Step 7: | Off |
Step 8: | On |