Here’s the default/basic setup. A good place to start from.
In order to demonstrate fine control of the settings, contributors are encouraged to enter ranges that normally go from 0 to 10 as 0 to 100 instead. Settings that are normally -5 to 5 become -50 to 50. Keep this in mind when setting up your MS-20.
| Waveform: | Saw |
| Pulse Width: | 50 % |
| Scale: | 16' |
| Level: | 100 % |
| Waveform: | Saw |
| Pitch: | 0 |
| Scale: | 8' |
| Level: | 100 % |
| Cutoff Frequency: | 0 % |
| Peak: | 0 % |
| MG/T.Ext: | 0 % |
| EG2/Ext: | 0 % |
| Cutoff Frequency: | 100 % |
| Peak: | 0 % |
| MG/T.Ext: | 0 % |
| EG2/Ext: | 0 % |
| Portamento: | 0 % |
| Tune: | 0 |
| MG/T.Ext: | 0 % |
| EG2/Ext: | 0 % |
| Waveform: | 50 % |
| Frequency: | 50 % |
| Delay Time: | 0 % |
| Attack Time: | 0 % |
| Release Time: | 0 % |
| Hold Time: | 0 % |
| Attack Time: | 0 % |
| Decay Time: | 0 % |
| Sustain Level: | 100 % |
| Release Time: | 0 % |
| Signal Level: | 0 % |
| Low Cut Freq: | 0 % |
| High Cut Freq: | 0 % |
| CV Adjust: | 0 % |
| Threshold Level: | 0 % |
SynthLib